!!! Available NOW !!!

LaserBee I

1 Watt (1000mW) Laser Power Meter + Thermopile Sensor

(Tests most Lasers from 5mW to 1050mW output power in 1mW increments.)

The 1 Watt LaserBee I comes pre-assembled and Pre-Calibrated so you can use it as soon as it arrives.

This 1 Watt Laser Power Meter was designed to let the hobbyist technician
know the output power of almost any Laser up to 1050mW.

It does NOT require an optical correction factor chart.... It does NOT use a photodiode sensor...

The 1 Watt LaserBee I uses an included Thermopile Sensor Head.

The 1 Watt Laserbee I is calibrated using a Newport Model 1825-C Laser Power Meter.
The 8x2 LCD module comes with a male connector and a female on the PCB so you can make an extension if needed.
The Sensor is now connected by a 3 Pin screw type Terminal Block on the PCB so that it can be disconnected.

There is now a Power LED on the PCB as well as an on-board removable jumper to disconnect power
to the now functional LCD Backlight if you need to conserve battery power.

The 1 Watt LaserBee I can now test most Lasers from 5mW to 1050mW output power in 1mW increments.

Easy to operate... simply attach a single 9 volt battery... shine the Laser Beam onto the Thermopile Sensor
and read almost any Wavelength Laser's power output directly on the LCD Display.



Comes with clear and easy to understand User Instructions....
Can be used with other Thermopile Sensors....
Can be re-calibrated by yourself if you have a calibrated Laser Power Meter
and a stable 100mW to 600mw Laser....

The new LaserBEE I now has a Data Logging Feature Option.
With the Data Logging Option...
you can Data Log the LaserBee I's output to the Data Logging PC Interface Software....
You can then Graph your data on screen and/or print it out to a Printer....
Even the RS232 Data Cable is included with the Data Logging Option.



For those of you, like some of us, that have trouble reading the 8x2 LCD display...
We will soon have a DOS based PC Interface that is Full Screen
with a Large Analog and Large Digital Display.
The DOS version will also Data Log to a file.

With this DOS software you can now dust off that old 486 or Pentium I, II, III,
and use it without Windows as a dedicated LPM Display.
Of course this DOS based Software will also work on computers running Windows 98,ME,2000.
(the DOS version has not been tested on XP or Vista)